Kintsugi Small Portion Putty 2-Piece Set for Ceramic Repair, Chipped Ware, Ceramic Powder, Tightbond

This is an item from the #toikichi_kintsugi series. You can see other items in the list.

This is a 2-piece set of putty materials for repairing chipped ceramics!
To perform kintsugi, you will need additional kintsugi paint.
We also have individual listings, such as Solve it with these 3 items, which include paint.
Click #toikichi_kintsugi to view!

This listing is for those who already have kintsugi paint (Pebeo).

Of course, it can also be used for repairing general ceramic items in daily life.
Repairing tiles, washbasins, toilets, and other ceramic items.

Make a putty by mixing ceramic powder and Titebond 3 in a rough ratio of approximately 1:1.
Don't be too particular about the mixing ratio; your own sense is fine.
(Be careful not to make too much, as only a small amount is needed. Add a little at a time as you observe.)

Apply to the chipped area and let it dry.
I like to shape it with my bare hands while it's slightly hardening.
Even if you work with your bare hands, it takes time to harden, so it will wash off.
Once it hardens a bit more, I scrape off any excess rough edges with my fingernails.
(It will become smooth with paint in the end, so don't be too fussy!)

● Holbein Pigment Ceramic Balloon Fine Grain 5 grams
● Franklin Titebond 3
The container has been improved and updated.
It's an eyedropper bottle with a screw cap. It's a 5ml capacity, but we put 6ml in it.
(Storage, sealing, and ease of use have been improved.)
As a test, I made putty for the two plates shown in the image with this container, but only a very small amount was used, and most of it was left over.

Titebond III has received food safety approval from the U.S. Food and Drug Administration (FDA), a national public institution.
It is best stored at room temperature in the room where you normally spend your time.
It becomes smoother when warm, so it's a good idea to warm it in your hands before use.

It will be shipped by non-standard mail, but in a standard envelope for non-standard mail.

#DIY #SimpleKintsugiKit #Titebond3 #CeramicPowder #KintsugiKit

This was listed because I wanted to have the items ready when needed, but since something always comes up, I keep them in stock and ready to go f^_^;

#SimpleKintsugi #Kintsugi #KintsugiStyle #KintsugiBeginner #ModernKintsugi #Tile #ChipFiller #Chip #Putty